ABG8820摊铺机继电器#4RD00790302

继电器能够将整个电路作用的范围增大，达到控制功率较大的电路目的，让其可以自动化运转。继电器的原理就是当输入量处在一个定值时，改变它的工作状态，避免发生意外。

继电器的正确使用方法

1. 使用继电器尽可能按照指导书来使用，而且每个参数都要在规定范围之内，这样才能保证足够的安全，然后就是继电器的负载和使用时间不能确定，因为会根据周边的环境负载不同做出改变。

2. 若是在室内使用直流继电器，那就需要矩形波来执行工作，交流继电器的话，就需要用正弦波来执行工作，另外继电器最好不要受到撞击，否则会导致内部元件遭到损坏。

3. 继电器在使用过程中，要确保周边环境温度、湿度适中，且空气中不能有有毒气体，这些都会影响继电器的使用。

免责声明丨 部分内容来源网络！本文仅供交流学习 , 版权归属原作者，部分图片、内容推送时未能及时与原作者取得联系，若来源标注错误或侵犯到您的权益烦请告知，我们将立即删除.

企业介绍

公司供应摊铺机配件，压路机配件，铣刨机配件，摊铺机刮板驱动轴，刮板驱动轴总成，找平仪，找平仪支架以及液压泵和配件。我厂还供应摊铺机易损件，摊铺机平衡梁，搅龙轴，踏板，输料底板，叶片，熨平板，减速机，链轨，履带板，支重轮，刮板大链条，输料链条等。

联系人：梁经理

联系方式：13645201509（微信同号）

QQ：2870202745

Relays can increase the range of the entire circuit, achieving the goal of controlling high-power circuits and allowing them to operate automatically. The principle of a relay is to change its working state when the input is at a fixed value to avoid accidents.

Correct usage of relays

1. When using relays, try to follow the instructions as much as possible, and each parameter must be within the specified range to ensure sufficient safety. However, the load and usage time of the relay cannot be determined, as it will change depending on the surrounding environmental load.

If a DC relay is used indoors, rectangular waves are required to perform the work. For an AC relay, sine waves are required to perform the work. Additionally, it is best not to impact the relay, as it may cause damage to internal components.

During the use of the relay, it is necessary to ensure that the surrounding environment temperature and humidity are moderate, and there are no toxic gases in the air, which can affect the use of the relay.

Disclaimer | Part of the content comes from the internet! This article is for communication and learning purposes only. The copyright belongs to the original author. Some images and content were not promptly communicated to the original author during push notifications. If the source labeling is incorrect or infringes on your rights, please inform us and we will immediately delete it

Enterprise Introduction

The company supplies paver accessories, roller accessories, milling machine accessories, paver scraper drive shaft, scraper drive shaft assembly, leveling instrument, leveling instrument support, hydraulic pump and accessories. Our factory also supplies vulnerable parts of paver, balance beam of paver, auger shaft, pedal, conveying bottom plate, blade, screed, reducer, chain rail, track plate, supporting wheel, scraper large chain, conveying chain, etc.

Contact person: Manager Liang

Contact information: 13645201509 (same WeChat account)

QQ：2870202745